Login
Lead levels in water may temporarily increase following a service line replacement or disturbance. Once water has been restored to your home, you must follow the flushing process.
-
After your line has been replaced and water is restored, do the following process one time:
1. Remove aerators/screens from all faucets including showerheads. The aerator is usually at the tip of the faucet and can be unscrewed to remove and clean.
2. Run COLD water from the lowest level of the home, closest to the service line (usually an outside hose bibb or downstairs bathroom) for 20 minutes. Allow a strong stream of water to flow to flush out any potential lead particles that may have come loose and been captured in the internal plumbing.
3. While the lowest level faucet is still running, work your way through the rest of the house to the highest, farthest faucet.
4. When all faucets are on/ opened, let the water run for an additional 20 minutes.
5. After 20 minutes, turn off faucets in the same order you turned them on.
6. Clean aerators/screens at each faucet and replace if needed.
-
For the next six months after line replacement:
1. Run water through the plumbing in your home for two minutes each morning (or after any period of inactivity/no water use of six hours or more) before drinking or cooking. This can be done by taking a shower, running the dishwasher or running cold water through the faucet.
2. Avoid consuming hot water directly from the tap, especially if preparing baby formula.
3. Keep in mind: boiling water does NOT reduce lead levels.
4. Consider having your child(ren)’s blood tested for lead as a precaution.
5. Continue to use the Brita water pitcher M.U.D. supplied you to reduce lead in drinking water OR use bottled water. If you use the pitcher beyond six months, follow the manufacturer’s instructions for filter replacement.